Fuses (35); Assistance And Repairs; Storage - Stiga Park 4WD Serie Manuel D'utilisation

(Translation of the Original Instructions)
Object Action
Control Lubricate the cable ends
with oil
cables
when each control is
activated.
This operation must be
carried out by two people.

9.13 FUSES (35)

Destination
Fuel valve power supply
Electrical cutting height
adjustment power supply
Electrical system power supply 30 A

10 ASSISTANCE AND REPAIRS

This manual provides all the necessary infor-
mation to run the machine and for correct basic
maintenance operations which can be performed
by the user.
Any regulations and maintenance operations not
described herein must be carried out by your De-
aler or Authorized Service Centre, which have the
necessary knowledge and equipment to ensure
that the work is carried out correctly, maintaining
the correct degree of safety and the original opera-
ting conditions of the machine.
Before performing any servicing opera-
tions:
a. Place the machine on a flat surface.
b. Activate the parking brake (10:B)
c. Stop the engine.
d. Remove the key from the ignition.
Authorized service workshops carry out guaran-
teed repairs and maintenance.
Always use genuine spare parts.
Genuine STIGA SpA spare parts and
accessories were designed specifically
for STIGA SpA machines.
Please remember that non-genuine
spare parts and accessories have not
been verified or approved by STIGA
SpA.
The use of non-genuine spare parts
and accessories could adversely affect
machine operation and safety.
STIGA SpA shall decline all liability in
the event of injuries or damages caused
ENGLISH
Fig.
30C
Fuse
10 A
20 A
by such parts.
Genuine spare parts are supplied by
authorized assistance workshops and
dealers.
It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance and
safety device inspection.

11 STORAGE

1. Empty the fuel tank:
• Start the machine's engine and leave it
running until it stops.
1. Change the oil when the engine is still warm.
2. Thoroughly clean the whole machine. It is
particularly important to clean the bottom
side of the cutting means assembly.
3. If the paintwork is damaged, touch it up to
prevent rust.
4. Place the machine in a covered, dry place.
For machines with electric starter:
If the storage temperature is correct, simply
recharge the batter every four months.
Charge the battery before putting the
machine into storage.
The battery can be seriously damaged
it if is put into storage flat.
EN
23