Key To Symbols - Jonsered CS 2186 Manuel D'utilisation

Symbols
CAUTION! Chain saws can be dangerous!
Careless or incorrect use can result in
serious or fatal injury to the operator or
others.
Please read the instructions carefully and
make sure you understand them before
using the saw.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective glasses or visor
Both of the operator´s hands must be used
to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any object
should be avoided.
Tip contact may cause the guide bar to
move suddenly upward and backward,
which may cause serious injury.
Other approved bar and chain combinations
in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Measured maximum kickback value without
triggering the brake, for the bar and chain
combination on the label.
2
– English

KEY TO SYMBOLS

Recommended cutting
equipment in this example:
- Bar length 16 inches
- Max. nose radius 10 Teeth
- Chain type Oregon 21LP
Switch off the engine by moving the stop
switch to the STOP position before
carrying out any checks or maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective glasses or a visor must be
worn.
Refuelling
Chain oil and chain oil flow adjustment
Other symbols/decals on the machine refer to special
certification requirements for certain markets.