Symbols On The Machine; Key To Symbols - Jonsered CS 2172 WH Manuel D'utilisation

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be
used to operate the chain saw.
Never operate a chain saw holding it
with one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
Recommended cutting
equipment in this example:
- Bar length 20 inches
- Max tooth count for the bar
nose sprocket is 11T
- Chain type Jonsered H42
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
Chain brake, activated (right) Chain
brake, not activated (left)
2 – English
All manuals and user guides at all-guides.com

KEY TO SYMBOLS

Decompression valve: The valve is to
reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
Ignition; choke: Set the choke control in
the choke position. This should
automatically set the stop switch to the
start position.
Adjustment of the oil pump.
If your machine bears this symbol it is
equipped with heated handles.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
1153687-49 Rev.2 2015-09-02