ELNA 664 Mode D'emploi page 38

1
1
2
3
A
6
4
All manuals and user guides at all-guides.com
• If one of the threads is broken, follow the
* Turn off the power switch and unplug the
1. Raise the presser foot and pull the thread chain
2. Re-thread the thread which had been broken.
2
3. Turn the handwheel toward you until the needle
3
4. Pull the threads from under the presser foot with
4
5
3
36
re-threading procedure as follows:
machine.
out to the back of the presser foot, and cut the
chain to separate each of the threads.
1 Cut off the tangled threads.
Example: Re-thread the lower looper thread.
2 Lower looper thread
comes to its highest position.
3 Needle thread
tweezers and pull out the needle threads above
the needle plate. Draw out 10 cm (4˝) away from
the presser foot. (Draw the needle thread in the
direction A)
3 Needle thread
4 Needle
5 Presser foot
6 Needle plate