The Position Of Thread Guide Bar; Attaching The Spool Holder Cap And Net - ELNA 664 Mode D'emploi

2
1
1
1
2
All manuals and user guides at all-guides.com

The Position of Thread Guide Bar

1
Pull the thread guide bar up as far as it will go.
Turn the thread guide bar so that the thread
guides are right above the spool pins.
3
4
* Make sure the two stoppers on the thread guide

Attaching the Spool Holder Cap and Net

3
1. When you use a small thread spool, pull out the
2
2. If the thread slips down from the spool
2
18
1 Thread guide bar
2 Thread guide
3
Stoppers
4 Spool pin
shaft, as shown, are set in at the correct position.
spool holder from the spool pin. Then place the
spool and put the spool holder cap on top of it.
1 Spool holder
2
Spool pin
3
Spool holder cap
during threading and/or sewing, put a net on the
spool as illustrated to prevent jamming.
1 Net
2 Spool pin