Power Fist 8567356 Manuel D'utilisateur page 5

V4.0
3 in. 3.5A Electric Cut·Off Tool 8567356
2. Avoid wearing clothes or jewelry that can become entangled with the
moving parts of a tool. Keep long hair covered or bound.
3. Do not overreach when operating the tool. Proper footing and
balance enables better control in unexpected situations.
4. Support the workpiece or clamp it to a stable platform. Holding the
workpiece by hand or against your body may lead to personal injury.
5. Securely hold this tool using both hands. Using a tool with only one
hand can result in loss of control.
6. Use clamps or other practical ways to support or secure the
workpiece to a stable platform.
SPECIFIC SAFETY PRECAUTIONS
1. Only use accessories that are specifically designed for use with the
tool. Make sure accessories are capable of handling the tool's
maximum speed of 24,000 RPM. Ensure the accessory is
tightly installed.
2. Keep hands and fingers away from cutting area. Any body part
coming in contact with moving parts could cause injury.
3. To maintain complete control, firmly hold your tool with both hands.
Do not place hands over air vents. Proper cooling of the motor is
necessary to ensure normal life of the tool.
4. Never point the cutter towards yourself. If it should slip, part of your
body could come in contact with moving parts.
5. Never force the tool. Excessive pressure could bend or break the
mandrel, resulting in damage to the tool, your workpiece or serious
personal injury. If your cut-off tool runs smoothly under no load, but
does not run smoothly under load, then excessive pressure is
being used.
6. This tool will not stop moving immediately. Do not lay the tool down
or leave it unattended until it has come to a complete stop. A part that
is moving could make the tool jump or grab a surface and pull the
tool out of your control.
Visit www.princessauto.com for more information 5