Power Fist 8567356 Manuel D'utilisateur page 10

8567356 3 in. 3.5A Electric Cut·Off Tool
V4.0
5. Never restart the cutting operation in the workpiece. Allow the wheel
to reach full speed and carefully reenter the cut. If saw blade is
binding, it may walk up or kickback from the workpiece as the cut-off
saw is restarted.
6. Support large panels to minimize the risk of disc pinching and
kickback. Large panels tend to sag under their own weight. Supports
must be placed under the panel on both sides, near the line of cut
and near the edge of the panel.
7. To minimize the risk of disc pinching and kickback, when cutting
operation requires the resting of the tool on the workpiece, the tool
should be rested on the larger portion and the smaller piece cut off.
8. Use extra caution when making a "plunge cut" into existing walls or
other blind areas. The protruding disc may cut objects that can
cause kickback.
9. Only use discs designed for tool. Do not use dull or damaged discs.
Unsharpened or improperly set discs produce narrow cut causing
excessive friction, disc binding and kickback. Keep discs sharp and
clean. Gum and wood pitch hardened on blades slows the tool and
increases potential for kickback.
10. Never force the tool. Forcing the tool can cause uneven cuts, loss of
accuracy, and possible kickback. Push the tool forward at a speed so
that the disc cuts without slowing.
VIBRATION PRECAUTIONS
This tool vibrates during use. Repeated or long-term exposure to
vibration may cause temporary or permanent physical injury, particularly
to the hands, arms and shoulders.
10 For technical questions call1·800-665-8685