On/Off Switch; Pre-Operation - Power Fist 8567356 Manuel D'utilisateur

8567356
OPERATION
ON/OFF SWITCH
3 in. 3.5A Electric Cut·Off Tool V4.0
WARNING! Before starting the tool, make sure the cutting disc is in
good condition, is properly installed and not in contact with
any surface.
This tool has a combination lock-out and ON/OFF switch to avoid
unintentional starting of the tool. To turn the switch ON:
1. Grasp the tool with both hands.
Fig.4
1
2. Press downward on the rear of the
ON/OFF switch with your thumb.
(See figure 4)
3. While pressing downward on the rear
of the ON/OFF switch, slide the switch
forward to start the tool.
NOTE: The ON/OFF switch will click into the lock-on position when the
switch button is pushed fully forward. The tool will continue to operate
until the switch is turned off.
4. To turn the tool OFF, press downward on the rear of the
switch button.
PRE-OPERATION
Verify the following every time the cut-off tool is used:
1. The cut-off disc is in good condition and properly installed on
the tool.
2. The guard is properly positioned on the tool and in the correct
position to protect the operator.
3. The workpiece is firmly clamped in a vise or to a stable work surface.
4. Safety glasses and appropriate safety gear are being worn.
5. No flammable liquids or materials are in the area.
16 For technical questions call1·800-665-8685