Assembly; Assembling The Bag Support Accessory - Titan PowrPlast 1000 Mode D'emploi

GB
COMMISSIONING
6.2.2
ASSEMBLY FIG. 5
Push the clamping lever (1) forwards to release the lock.
Unhook the hooks (2) and fold them away to the side.
Remove the pump unit (3) at the container from the rotor (4).
Using the supplied specialised wrench, loosen the union nut
(5) on the pump unit (3) to separate the pump unit from the
pump tube (6).
Spray stator (7) with a suitable pump lubricant.
Insert stator (7) in pump tube (6) such that the journal sits in
the largest recess.
Spray rotor (4) with a suitable pump lubricant (order no. 9992
824).
Move selector switch (8) to "A" and set delivery volume con-
troller (9) to „0".
Connect mains plug to mains power supply.
The operation light (10) shows operational readiness.
Disconnect the remote control and exter-
nal controls. Only the person controlling
the machine may assemble the pump
unit.
Never operate mortar spraying machine
with an exposed rotor.
Do not reach into the rotor when it is
moving. Risk of crushing.
Caution if you have long hair. Only wear
close- tting clothes at work.
Insert the pump unit (3) into the guide rails and push over the
rotor (4).
Hold on to the pump unit at the container.
Set delivery volume controller (9) to 1 or 2.
Set the selector switch (8) to "R" and hold it there to allow the
pump to run in reverse. The pump unit is automatically drawn
up by the rotor.
As soon as the pump unit has reached the nal position, re-
lease the selector switch (8).
Hook both hooks (2) into the pump unit and push the clamp-
ing lever (1) up as far as it goes to secure the pump unit.
After assembling the pump unit, secure the
union nut (5) on the pump unit, using the spe-
cialised wrench to do so. In the process, we
recommend running the machine at a slow
pace (selector switch on "F").
6.2.3

ASSEMBLING THE BAG SUPPORT ACCESSORY

Insert the bag support ( g. 6.1) into the holes at the top of the
PowrPlast 1000.
Secure from below using the 4 hex bolts.
36

1 2
10
POWER ERROR
SPEED
8 9

PowrPlast 1000
4
7
1
5
3
6