Connecting The Spray Lance; Remote Control (Accessory); Remote Control Assembly - Titan PowrPlast 1000 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB
COMMISSIONING
6.6
CONNECTING THE SPRAY LANCE FIG. 10
• Select a spray tip suitable for the material:
The tip size should amount to at least three times the
granular size, e.g.
granular size arti cial resin plasters –> 3 mm
Tip size –> 10 mm
• Mount the texture tip (1) in the spray lance with the cone
pointing towards the spray head.
• Connect the spray lance (2) to the material hose and secure
by applying the levers (3).
• Close the material tap (4) (material tap points forwards).
• Connect atomization air connection (5) to the air hose of the
mortar hose.
• Screw coupling plug (6) for remote control to the control ca-
ble of the mortar hose. (Automatic version only)
• Connect mortar hose's control cable to pump connection.
(Fig. 12) (Automatic version only)
• Set selector switch to "A".
6.7
REMOTE CONTROL ACCESSORY/ NOT INCLUDED
IN THE SCOPE OF DELIVERY
The remote control can be used to set the operating mode
(Fig. 13, 1) and delivery volume (Fig. 13, 2) without the opera-
tor having to physically go to the machine.
The remote control can be secured to the spray lance with a
cable tie.
6.7.1

REMOTE CONTROL ASSEMBLY

• Ensure that the selector switch (Fig. 14, 1) is in the "A" posi-
tion and that the mains plug is disconnected.
• Connect connection cable to connection.
• Connect mains plug to mains power supply.
When the remote control is attached, the
PowrPlast 1000 can no longer be controlled
via the device operating panel.
If the connection cable is disconnected from
the pump, the pump automatically switches
o .
38
3
5
6
1
2
ELEC
PNEUM
REMOTE
Control
Controler
PowrPlast 1000
2
4
ELEC
PNEUM
REMOTE
Controler
Control
POWER ERROR
1
1
SPEED

Publicité

Table des Matières
loading

Table des Matières