Maintenance; Daily Maintenance; Maintaining The Filter Assembly - Titan PT6900 Plus DI 120V Mode D'emploi

Maintenance

6. Maintenance
Before proceeding, follow the Pressure Relief
Procedure outlined previously in this manual.
Additionally, follow all other warnings to reduce the
risk of an injection injury, injury from moving parts
or electric shock. Always unplug the sprayer before
servicing!
6.1

Daily Maintenance

Two daily procedures are required for routine operator maintenance
on this sprayer:
A. Lubricating the upper packings.
B. Cleaning the filter screen
A) Lubricating the Upper Packings
1. Clean out the paint that has seeped past the upper packings
into the packing oil reservoir (fig. 13, item 1) above the fluid
section.
2. Fill the packing oil reservoir 1/2 full with Piston Lube (P/N 314-
480) supplied by the factory. This will extend packing life.
PT6900
i
Do not over-fill the reservoir so that it overflows and
drips into the paint.
B1) Cleaning the Filter Screen (PT6900 Plus DI)
1. The filter screen will clog and must be cleaned at least once a
day.
2. Remove the retaining ring (Fig. 14, item 1) from the foot valve
housing (2).
3. Remove the inlet screen (3) from the foot valve housing (2).
4. Clean thoroughly with the appropriate solvent.
1
PT12000
2
3
1
GB
B2) Cleaning the Filter Screen (PT12000 Plus DI)
1. The filter screen will clog and must be cleaned at least once a
day.
2. Loosen and remove the inlet screen (Fig. 15, item 1) from the
siphon tube (2).
3. Clean thoroughly with the appropriate solvent.
6.2

Maintaining the Filter Assembly

Clean the filter regularly. Dirty or clogged filters can greatly reduce
filtering ability and cause a number of system problems including
poor spray patterns, clogged spray tips, etc.
Cleaning (Fig. 16)
To clean the filter, perform the following procedure.
1. Follow the "Pressure Relief Procedure" found in the Operation
section of this manual.
2. Remove the filter cap assembly (1) and spring (2).
3. Pull the filter element with ball straight (3) out of the filter
body (4).
4. Clean inside the filter body, filter element with ball, and filter
cap assembly using the appropriate solvent.
i
Use care in handling parts as dirt, debris, scratches,
or nicks may prevent o-rings or gaskets from sealing.
This filter element filters from the inside out. Be sure
to clean the filter element thoroughly on the inside.
Soak in solvent to loosen hardened paint or replace.
1
2
3
7
8
5
6
4
16
2
1
PowrTwin Plus DI