Remote Menu - Sony LMD-3250MD Instructions D'utilisation

COMPUTER DETECT
USER CONFIG – COMPUTER DETECT
DV I :
H D 1 5 :
Submenu Setting
COMPUTER The appropriate preset memory is set for
DETECT the signal from DVI and HD15 input
connector. Select "PRESET1" for the
standard PC signal. Select "PRESET2"
to "PRESET8" when the PC signal is not
standard (on page 73).
The preset memory is set for each input
connector of DVI and HD15.
Note
"PRESET7" and "PRESET8" will only
be displayed when "DVI" is selected.

REMOTE menu

REMOTE
PA R A L L E L R E M O T E :
S E R I A L R E M O T E :
M O N I T O R :
68
Adjustment Using the Menus
xxxxx
xxxxx
xxxxxxx
Submenu Setting
PARALLEL REMOTE Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
pins 1 to 4 and pins 6 to 8. The
following lists the functions you
can assign to the pins.
• – – – ("– – –": No function is
assigned.)
• COMPOSITE
• Y/C
• RGB
• COMPONENT
• DVI
• HD15
• OPTION A-1
• OPTION A-2
• OPTION B-1
• OPTION B-2
• OVERSCAN
• NORMAL
• NATIVE
• 4:3
• 16:9
• TALLY G
• EXT SYNC
• BLUE ONLY
• MONO
• MIRROR IMAGE
Note
If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 72.
SERIAL REMOTE Selects the mode to be used.
• OFF: SERIAL REMOTE does
• RS-232C: The monitor is
• ETHERNET: The monitor is
MONITOR Set the monitor setting.
not function.
controlled by the command
of RS-232C.
controlled by the command
of Ethernet.
IP ADDRESS: Sets the IP
address.
SUBNET MASK: Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY:
Sets the default gateway on
or off.
ADDRESS: Sets the default
gateway.
CANCEL: Selects to cancel
the setting.
CONFIRM: Selects to save
the setting.