Chicco KeyFit 30 Mode D'emploi page 50

INSTALL CARRIER TO BASE
3
Check to make sure the Carrier is securely attached to the Base.
ALWAYS lift up on Carrier to verify it is properly attached to the Base.
ALWAYS place handle in LOCKED "CARRY" position when using infant restraint
system in vehicle.
CHECK YOUR WORK
Hold Base at each side and pull side to side and forward. Child Restraint

should not move more than 25 mm (1 inch) from vehicle seat back or
side-to-side.
Make sure Child Restraint is level by confirming that the bubble on the

level indicator is between the level lines. Make sure infant's head does
not fall forward. If necessary, re-adjust recline and repeat installation
steps to make sure Child Restraint is installed properly.

Check installation before every use!
48