Chicco KeyFit 30 Mode D'emploi page 60

INSTALL USING LAP BELT ONLY
Put the vehicle seat belt in the locked mode, see vehicle owner's manual for
more information. A tightly rolled towel may be used under the front edge of the
Carrier if needed to adjust the angle of the Carrier. Angle is correct when level line
on Carrier is level with ground.
While pushing down on the Child Restraint, pull up on the loose end of
3
the vehicle lap belt to remove all slack.
CHECK YOUR WORK
 Hold Child Restraint at each side and pull side to side and forward.
Child Restraint should not move more than 25 mm (1 inch) from vehicle
seat back or side-to-side.
Make sure Child Restraint is level. Make sure infant's head does not fall

forward. If necessary re-adjust recline and repeat installation steps to
make sure Child Restraint is installed properly.

Check installation before every use!
58