Before Use; Scope Of Application; Contraindications; Setting Up The Lumina Smart - Precision Tech Lumina Smart Manuel Utilisateur

2. BEFORE USE

2.1 Scope of application

Suitable for the purpose of curing dental resins and composites or detecting caries.
This device must only be used in hospital environments, clinics or dental offices by qualified dental per-
sonnel.

2.2 Contraindications

Do not use the device for non-endodontic dental procedures.
Safety and effectiveness have not been established in pregnant women and children.
Warning
Read the following warnings before use:
• The device must not be placed in humid surroundings or anywhere where it can come into
contact with any type of liquids.
• Do not expose the device to direct or indirect heat sources. The device must be operated
and stored in a safe environment.
• The device requires special precautions with regard to electromagnetic compatibility
(EMC) and must be installed and operated in strict compliance with the EMC information.
In particular, do not use the device in the vicinity of fluorescent lamps, radio transmitters,
remote controls, portable or mobile RF communication devices and do not use this system
near the active HF Surgical Equipment in the hospital. Do not charge, operate or store at
high temperatures. Comply with the specified operating and storage conditions.
• Protective light shield and a disposable sleeve are compulsory during treatment.
• If irregularities occur in the device during treatment, switch it off. Contact the agency.
• Never open or repair the device yourself, otherwise, void the warranty.

3. SETTING UP THE LUMINA SMART

3.1 Install the light source head

Warning
• After connecting the light source head and the handpiece, pull it gently to make sure the
connection is good.
• Make sure the assembly is connected properly, otherwise might cause unexpected fault,
even hurt the patients.
1. Make sure the light source head alignment the
slots of handpiece, plug them together until it "cli-
ck" securely into place.
2. The light source head can be 360 degrees ro-
tated without take off, make it easy to watch the
LCD in treatment.
25