Setting; Selecting Memory; Light Intensity Setting; Advanced Setting - Precision Tech Lumina Smart Manuel Utilisateur

5. SETTING

5.1 Selecting memory

5.2 Advanced setting

28
MEMORY CHANGE
There are 6 built-in memory programs, namely M0, M1, M2, RAMP,
PULSE, Detect. Press setting key to change the memory during standby
state.

LIGHT INTENSITY SETTING

The memory programs of M0, M1 and M2 can be customized to
2300mW/cm , 1500mW/cm
2
the light intensity setting menu, then press
switch to confirm and exit.
On the light intensity setting menu, long press
setting menu.
Note
• The light intensity of RAMP, PULSE and Detect memory programs are
built-in, and the user cannot modify the settings.
CURING TIME SETTING
In the curing time setting menu, press
time selection is different under different light intensity:
Light intensity(mW/cm
2300
1500
1000
600
Long press or short press to exit the setting.
The current memory program automatically saves the setting parameters.
During power off state, holding down press
the "Auto power off time" setting. It can be set to 1min, 5min, 10min or
15min. Press to change setting, press
"Volume" volume setting mode.
or 1000mW/cm
2
to select different times. The
) Time selection(sec)
2
01,02,03
05,10,15,20
05,10,15,20
10,15,20,25
. Long Press to enter
2
to change or press main
to enter the time
, then press to entry
to enter the next setting