Install The Disposable Sleeve; Install The Protective Light Shield; Charging - Precision Tech Lumina Smart Manuel Utilisateur

3.2 Install the disposable sleeve

3.3 Install the protective light shield

3.4 Charging

26
1. Take a disposable sleeve and gently insert it into
the handpiece from the light source head.
1. Make sure the light source head alignment the
slots of the protective light shield, plug them to-
gether.
2. Avoid direct exposure of the lamp to the eyes
during working.
Warning
• Disposable sleeve must be discarded after use.
• The light source head, protective light shield
and handpiece should be cleaned and
disinfected after each treatment.
1. Plug the USB of adapter into the charge base,
and plug the other end into a power outlet, the
Power LED on charge base will light up (green).
Note
• Only the original adapter could be used.
2. Put the handpiece all the way into the charge
base, the charge state will show on the screen.
3. Charging indication appears on the screen,
and flashes slowly, when battery is fully charged
or in a state near full charge, the flash will stop.
Note
• Put the handpiece into the charge base in the
right direction, otherwise the handpiece will
not be recharged.