Handpiece Operation - Precision Tech Lumina Smart Manuel Utilisateur

6.2 Handpiece operation

Warning
• Before using, please try it outside the oral cavity to ensure that there is no problem with the function
of the device.
• Do not disassemble the lamp during treatment.
Note
• If there is any abnormal functioning, stop using the device and report to company
• Gloves are compulsory during treatment
• Always clean the handpiece and light source head after each treatment.
30
1. After the handpiece main unit is turned on, press
intensity output, and the time will start counting down. Press any key to
interrupt the output during the light intensity output.
There is a beep every 5s while working, and the output is automatically
turned off after the countdown ends.
Warning
• When the device is working, do not directly illuminate the eyes,
otherwise it will cause injury.
• Do not directly illuminate the skin, otherwise high temperature burns
may occur.
Note
• After the device is used continuously for 10 times at 2300mW/cm
it will be prohibited to use the highest light intensity output within 1
minute. Used to prevent the lamp from overheating.
• When using, the light should be directly irradiated onto the curing
dental resins and composites to avoid improper exposure.
• The disposable protective cover and protective light shield are highly
recommended.
2. When the device is in standby mode, it will automatically shut down
when it reaches the set time. The factory default setting is 5 minutes.
to start the light
,
2