Shipping And Storage; Plastic Parts - Vermeiren Eclips X4 Mode D'emploi

All manuals and user guides at all-guides.com
4.2

Shipping and storage

The shipping and storage of the wheelchair shall be according following instructions:
•
Store in a dry place (between +5 ° C and +41 ° C).
•
The relative humidity of the air should be between 30% and 70%.
•
Provide sufficient covering or packaging to protect the wheelchair from rust and
foreign bodies. (e.g. salt water, sea air, sand, dust).
•
Store all removed parts together in one place (or mark them if necessary) to avoid
mixing up with other products when re-assembling.
•
Components must be stored without being subjected to strains (Do not put too heavy
parts on the wheelchair, not clamping between something, ...).
4.3 Care
4.3.1 Seat and back cushion
The cleaning of the seat and back cushion shall be according:
Clean seat and back with a cloth moistened with hot water. Be aware that you do not
soak the seat and back cushion.
Use a mild commercial detergent for removing stubborn dirt.
Stains can be removed by using a sponge or a soft brush.
Do not use strong cleaning liquids like solvents, nor use hard brushes.
Never clean with steam and/or pressure washers.

4.3.2 Plastic parts

Clean plastic parts of your wheelchair with commercial plastic cleaners. Only use a soft
brush or soft sponge. Examples of plastic parts are the armrests, footrests, handles, tyres
and ... .
4.3.3 Coating
The high quality of the surface layer guarantees optimal protection against corrosion. If the
outer coat is damaged by scratching or in some other way, get your specialist dealer to
repair the affected surface.
When cleaning, only use warm water and normal household detergents and soft brushes
and cloths. Ensure that no wetness gets into the tubes.
Initially the zinc parts only require rubbing with a dry cloth. Stubborn dirt can best be
removed by using a suitable commercial zinc polish.
4.4 Inspection
In principle we recommend one inspection every year, and a minimum of one before usage
is resumed. All of the following checks must be performed and documented by authorized
persons:
•
Check the frame parts and the hinged tubes for plastic deformation, cracks and
impaired functioning.
•
Visually check for damage to the paintwork (danger of corrosion)
•
Check the operation of the wheels (free running, level rolling, axle play, tyres, profile,
condition of the rims, air pressure in the case of air tyres, floating axles, etc.)
•
Check the solidity and seating of all screws.
•
Verify the amount of grease on the metal joints of movable parts
•
The condition and security of the guides and axles of the steering wheels
•
Visually check all plastic parts for cracks and brittle spots
Page 25
Eclips X4, Eclips X4 30°
2012-01