Operating The Brakes; Mounting Or Removing Of Arm Supports - Vermeiren Eclips X4 Mode D'emploi

All manuals and user guides at all-guides.com
2.5

Operating the brakes

L L L L
WARNING:
The brakes are not used to slow down the wheelchair during
movements – Use the brake only to prevent the wheelchair from unintended
movements.
L L L L
WARNING:
Good operation of the brakes is influenced by wear and
contamination of the tires (water, oil, mud, ...) – Check the condition of the tires
before each use.
L L L L
WARNING:
The brakes are adjustable and can wear – Check the operation of the
brakes before each use.
2.6

Mounting or removing of arm supports

L L L L
CAUTION:
Risk of clamping – Keep fingers, buckles and clothes away from the
bottom side of the arm support.
The arm supports of the wheelchair can be mounted by following instructions.
1. Mount the rear tube of the arm rest in tube hood
2. Make sure the arm support is mounted very well.
3. Fold the arm support to the front.
4. Pull lever on tube hood
5. Click the front tube of the arm support
A
To apply the brakes:
1. Push the brake handles
distinctive click.
L L L L
CAUTION:
Risk of unintended movement –
Make sure the wheelchair is on a flat
horizontal surface before releasing the
brakes. Never release both brakes
simultaneously.
To release the brakes:
1. Release one brake by pulling the handle
backwards.
2. Hold the hand-rim of the released wheel with
your hand.
3. Release the second brake by pulling the handle
backwards.
.
(Fig A)
upwards.
(Fig B)
in tube hood
Page 9
Eclips X4, Eclips X4 30°
2012-01
forward till you feel a
.
(Fig B)
B