Sharp FO-5800 Mode D'emploi page 154

Optional Settings
Note: If you select AFTER for the BILLING CODE DIAL selection, you
must press the REDIAL key after dialing if you use the SPEAKER key.
Setting 27: DEPARTMENT CODE DIGITS
Use this setting if you are using Telephone Billing and need to change
the number of digits of Department Codes to accord with your PBX's
telephone billing system. Enter any number from 3 to 9.
♦ Initial setting: 4
Setting 28: DISTINCTIVE RING
This sets the ring pattern to which your fax will answer if you
subscribe to a distinctive ring service. Enter a number from 1 to 7 to
select a pattern. See Distinctive Ring in Chapter 5 for more details.
♦ Initial setting: 7
Setting 29: VERIFICATION STAMP
Press 1 if you want the fax machine to stamp each original document
page as it is scanned. After scanning, you can check to see if all pages
have been stamped to verify that no double feeds occurred. Press 2 to
turn the function off.
Note: To use this function, your dealer must install the Verification
Stamp option.
♦ Initial setting: 2
Setting 30: PRINT HOLD
Press 1 if you want the fax machine to hold received documents in
memory instead of immediately printing them out (note that you must
first enter a Print Hold passcode as explained in Print Hold in Chapter
5). To turn off the Print Hold function, press 2, enter the 4-digit Print
Hold passcode, and then press START.
♦ Initial setting: 2
152
All manuals and user guides at all-guides.com