Sharp FO-5800 Mode D'emploi page 153

All manuals and user guides at all-guides.com
Setting 23: QUICK ON-LINE
When you transmit a multi-page document, this setting determines
whether the fax machine will dial the receiving party and begin
transmitting while scanning is still in progress, or wait until all pages
have been scanned before dialing. Press 1 to have the fax machine dial
and begin transmission while scanning is still in progress, or 2 to have
the fax machine wait until all pages have been scanned.
♦ Initial setting: 1
Setting 24: MULTI TTI
If you are using Department Control, you can press 1 to have the
department name (the name associated with the department code
entered by an operator to access the fax) appear at the top of each
transmitted document. This will appear in place of the name entered
in Entering Your Name and Fax Number in Chapter 1. Press 2 to turn
Multi TTI off (the sender's name entered in Chapter 1 will appear).
♦ Initial setting: 2
Setting 25: BEEP LENGTH
This sets the duration of the beep that signals the end of transmission,
reception, or copying. Press 1 for 3 seconds, 2 for 1 second, or 3 for
no beep.
♦ Initial setting: 1
Setting 26: TELEPHONE BILLING CODE
This setting allows you to use Department Codes or direct billing
codes for telephone billing on a PBX. (Your dealer must first activate
Department Control or direct billing code entry.) Press 1 to turn
telephone billing on, or 2 to turn it off.
♦ Initial setting: 2
If you pressed 1, the BILLING CODE DIAL selection will
subsequently appear. Press 1 if your PBX must receive the billing
code before dialing a telephone number, or 2 if it must receive the
billing code after dialling a telephone number. (Refer to your PBX
manual or consult your PBX adminstrator for this information.)
Optional Settings
151