Name Of Parts - Sanyo Classic PAC i SPW-C256VH Instructions D'installation

<How to clean the filter>
1. Remove the air filter from the air intake side.
2. Use a vacuum cleaner to remove light dust. If there is sticky
dust on the filter, wash the filter in lukewarm, soapy water,
rinse it in clean water, and dry it.
■ Troubleshooting
If your air conditioner does not work properly, first check the
following points before requesting service. If it still does not
work properly, contact your dealer or a service center.
Trouble Possible Cause
Air 1. Power failure.
conditioner
does not run
at all
2. Leakage circuit
breaker has tripped.
3. Line voltage is too low.
4. Operation button is
turned off.
5. The wired remote
control unit or
heat pump is
malfunctioning.
(The inspection mark
and the letters E, F,
H, L, P in combination
with numbers appear
on the LCD of the
wired remote control
unit.)
Compressor 1. Obstruction in front of
runs but condenser coil
soon stops
Poor cooling 1. Dirty or clogged air
(or heating) filter.
performance 2. Heat source or many
people in room.
3. Doors and/or windows
are open.
4. Obstacle near air
intake or air discharge
port.
5. Thermostat is set too
high for cooling (or too
low for heating).
6. (Defrosting system
does not work.)
■ Tips for Energy Saving
Avoid
● Do not block the air intake and outlet of the unit. If either
is obstructed, the unit will not work well, and may be
damaged.
● Do not let direct sunlight into the room. Use sunshades,
blinds or curtains. If the walls and ceiling of the room are
warmed by the sun, it will take longer to cool the room.
Do
● Always try to keep the air filter clean. (Refer to "Care and
Cleaning.") A clogged filter will impair the performance of the
unit.
● To prevent conditioned air from escaping, keep windows,
doors and any other openings closed.
NOTE
Should the power fail while the unit is running
If the power supply for this unit is temporarily cut off, the unit will
automatically resume operation once power is restored using
the same settings before the power was interrupted.
Remedy
1. After a power outage,
press ON/OFF operation
button on the wired remote
control unit.
2. Contact service center.
3. Consult your electrician or
dealer.
4. Press the button again.
5. Consult your dealer.
1. Remove obstruction
1. Clean air filter to improve
the airflow.
2. Eliminate heat source if
possible.
3. Shut them to keep the heat
(or cold) out.
4. Remove it to ensure good
airflow.
5. Set the temperature lower
(or higher).
6. (Consult your dealer.)
13-3. Ceiling-Mounted Type (T Type)

■ Name of Parts

CEILING-MOUNTED
T Type
■ Care and Cleaning
WARNING
● For safety, be sure to turn the air conditioner off and
also to disconnect the power before cleaning.
● Do not pour water on the indoor unit to clean it. This will
damage the internal components and cause an electric
shock hazard.
Air intake and outlet side (Indoor unit)
Clean the air intake and outlet side of the indoor unit with a
vacuum cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
water. When cleaning the air outlet side, be careful not to force
the vanes out of place.
CAUTION
● Never use solvents or harsh chemicals when cleaning
the indoor unit. Do not wipe plastic parts using very hot
water.
● Some metal edges and the fins are sharp and may cause
injury if handled improperly; be especially careful when
you clean these parts.
● The internal coil and other components must be cleaned
regularly. Consult your dealer or service center.
Air filter
The air filter collects dust and other particles from the air and
should be cleaned at regular intervals as indicated in the table
below or when the filter indication ( ) on the display of the
remote control unit (wired type) shows that the filter needs
cleaning. If the filter gets blocked, the efficiency of the air
conditioner drops greatly.
Type
T
NOT E
The frequency with which the filter should be cleaned depends
on the environment in which the unit is used.
86
Air outlet
Water drain
(Drain pipe can be
connected to either
the left or right side.)
Air intake grille
(air intake)
Period
2 weeks