Names Of Parts - Sanyo KHS3082 Mode D'emploi

01_KHS3682_EN.fm Page 4 Friday, February 12, 2010 12:42 PM

NAMES OF PARTS

Air intakes
Air outlet
Remote control unit
Refrigerant tubes
OUTDOOR UNIT
Air outlet
NOTE
This illustration is based on the external view of a standard model.
Consequently, the shape may differ from that of the air conditioner
which you have selected.
This air conditioner consists of an indoor unit and an outdoor unit.
You can control the air conditioner with the remote control unit.
Air Intake Air from the room is drawn into this section and
passes through air filters which remove dust.
Air Outlet Conditioned air is blown out of the air
conditioner through the air outlet.
Remote
The wireless remote control unit controls power
ON/OFF, operation mode selection,
Control Unit
temperature, fan speed, timer setting, and air
sweeping.
Refrigerant
The indoor and outdoor units are connected by
copper tubes through which refrigerant gas
Tubes
flows.
Drain Hose Moisture in the room condenses and drains off
through this hose.
Outdoor The outdoor unit contains the compressor, fan
motor, heat exchanger coil, and other electrical
(Condensing)
components.
Unit
4
INDOOR UNIT
Drain hose
UNIT DISPLAY AND OPERATION
BUTTON
INDOOR UNIT
OPERATION lamp
OPERATION button
(ON/OFF)
IMPORTANT
Avoid using radio equipment such as mobile phone near (within
4 ft. (1.2 m)) the remote control receiver. Some radio equipment
may cause malfunction of the unit.
If the trouble happens, disconnect power and restart the air
conditioner after a few minutes.
REMOTE This section picks up infrared signals from the
remote control unit (transmitter).
CONTROL
receiver
OPERATION When the remote control unit cannot be used,
pressing this button enables heating and
button
cooling operation.
Each time this button is pressed, the type of
operation conducted is indicated by the
changing color of the OPERATION lamp. Press
the button and select the lamp color that suits
your preference for operation.
Cooling
operation
(green)
OPERATION This lamp lights when the system is in the
continuous AUTO (red or green), HEAT (red),
lamp
DRY (orange), COOL (green) and FAN (green)
mode.
The OPERATION lamp lights up red and orange
alternately when the system is defrosting.
TIMER lamp This lamp lights when the system is being
controlled by the timer.
LED CLEAN This lamp lights during operation in the UV anti-
bacterial mode.
lamp
NOTE
The unit's display lamps are dimmed during operation in the NIGHT
SETBACK mode.
TIMER lamp
REMOTE CONTROL
receiver
LED CLEAN
lamp
Heating
Stop
operation
(lamp off)
(red)
OI-149-4-EG