Sanyo Classic PAC i SPW-C256VH Instructions D'installation page 91

■ Troubleshooting
If your air conditioner does not work properly, first check the
following points before requesting service. If it still does not
work properly, contact your dealer or a service center.
Trouble Possible Cause
Air 1. Power failure.
conditioner
does not run
at all
2. Leakage circuit breaker has
tripped.
3. Line voltage is too low.
4. Operation button is turned
off.
5. The wired remote control
unit or heat pump is
malfunctioning.
(The inspection mark
the letters E, F, H, L, P in
combination with numbers
appear on the LCD of the
wired remote control unit.)
Compressor 1. Obstruction in front of
runs but condenser coil
soon stops
Poor cooling 1. Dirty or clogged air filter.
(or heating) 2. Heat source or many people
performance in room.
3. Doors and/or windows are
open.
4. Obstacle near air intake or
air discharge port.
5. Thermostat is set too high
for cooling
(or too low for heating).
6. (Defrosting system does not
work.)
■ Tips for Energy Saving
Avoid
● Do not block the air intake and outlet of the unit. If either is
obstructed, the unit will not work well, and may be damaged.
● Do not let direct sunlight into the room. Use sunshades,
blinds or curtains. If the walls and ceiling of the room are
warmed by the sun, it will take longer to cool the room.
Do
● Always try to keep the air filter clean. (Refer to "Care and
Cleaning.") A clogged filter will impair the performance of the
unit.
● To prevent conditioned air from escaping, keep windows,
doors and any other openings closed.
N OT E
Should the power fail while the unit is running
If the power supply for this unit is temporarily cut off, the unit will
automatically resume operation once power is restored using
the same settings before the power was interrupted
Remedy
1. After a power outage,
press ON/OFF
operation button on
the wired remote
control unit.
2. Contact service
center.
3. Consult your
electrician or dealer.
4. Press the button
again.
5. Consult your dealer.
and
1. Remove obstruction
1. Clean air filter to
improve the airflow.
2. Eliminate heat source
if possible.
3. Shut them to keep the
heat (or cold) out.
4. Remove it to ensure
good airflow.
5. Set the temperature
lower (or higher).
6. (Consult your dealer.)
89