AFG 3.1AT Manuel Du Propriétaire page 9

TOOlS INClUdEd:
F 8 mm T-Wrench
F 5 mm T-Wrench
F 5 mm L-Wrench
F Screwdriver
PARTS INClUdEd:
F 1 Console Assembly
F 1 Handlebar Assembly
F 2 Console Mast Caps
F 2 Console Masts
F 2 Main Frame Boots
F 1 Hardware Kit
F 1 Safety Key
F 1 Power Cord
F 1 Audio Adapter Cable
NEEd HElP?
If you have questions or if
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back panel
of this manual.
All manuals and user guides at all-guides.com
PRE ASSEMBLY
UNPACkING
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Never open box when it is on its side. Once the banding straps have been removed,
do not lift or transport this unit unless it is fully assembled. Unpack and assemble the unit
where it will be used. Never grab hold of any portion of the incline frame and attempt to
lift or move the treadmill. Lift the treadmill from the roller end caps area while a second
person removes the parts packed under the treadmill.
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
such as lithium bike grease is recommended.
9