Material Preparation - WAGNER CONTROL SPRAY MAX Manuel De L'utilisateur

Material
preparation
Before you begin:
Before spraying, the material being used may
need to be thinned with the proper solvent
as specified by the material manufacturer.
Never exceed the thinning advice given by the
coating manufacturer.
Do not use materials with a
flashpoint below 70°F (21°C).
Material to be sprayed should always
be strained to remove any impurities in
the paint which may enter and clog the
system. Impurities in the paint will give poor
performance and a poor finish.
All manuals and user guides at all-guides.com
1 2
1. Stir the spraying material 2. Dip the viscosity test cup
thoroughly before measuring
viscosity.
4
4. Unscrew the cup from the spray gun.
5
3
Material
1) Oil enamel
2) Oil based primer
3) Oil stain
4) Clear sealer
5) Polyurethane
6) Varnish
7) Lacquer sanding sealer
8) Lacquer
9) Automotive finishes
10) Latex paint
3. Hold the test cup up and measure the time in
completely into the spraying seconds until the liquid empties out. This time is
material. referred to above as Runout time.
5
5. After the material has been properly
thinned and strained, fill the
container to the top of the neck.
Thinning Chart
Runout Time
25-40
30-45
No thinning required
No thinning required
No thinning required
20-50
25-35
25-35
20-40
Follow manufacturer's
recommendations
6
6. Carefully screw the cup back onto
the spray gun.
English