WAGNER CONTROL SPRAY MAX Manuel De L'utilisateur page 9

Troubleshooting (continued)
Problem C: Atomization is too coarse
Cause
1. Viscosity of material too high.
2. Material volume too large.
3. Material volume setting too high (+).
4. Pressure setting too low.
5. Nozzle clogged.
6. Air filter clogged.
7. Too little pressure build-up in container.
Problem D: Spray jet pulsates
Cause
1. Material in container running out.
2. Air filter clogged.
Problem E: Pattern runs or sags
Cause
1. Applying too much material.
Problem F: Too much overspray
Cause
1. Gun too far from spray object.
2. Too much material applied.
3. Pressure setting too high.
Problem G: Pattern is very light and splotchy
Cause
1. Moving the spray gun too fast.
Have you tried the recommendations above and
are still having problems? In the United States, to
speak to a customer service representative, call
our technical service at 1-800-328-8251 monday
through friday between 8:00 Am and 4:30 pm
central time.
All manuals and user guides at all-guides.com
Solution
Thin.
Decrease volume setting (-).
Decrease volume setting (-).
Increase pressure setting (+).
Clean.
Change.
Tighten container.
Solution
Refill.
Change.
Solution
Adjust material flow or increase movement of spray gun.
Solution
Reduce distance.
Decrease volume setting (-).
Decrease pressure setting.
Solution
Adjust material flow or decrease movement of spray gun.
9
Product Registration
Register your product online at www.wagnerspraytech.com.
Proper registration will serve as proof of purchase in the
event your original receipt becomes misplaced or lost.
English