Benning MM 2 Mode D'emploi page 16

Digital Multimeter for
- DC voltage measurement
- AC voltage measurement
- DC current measurement
- AC current measurement
- Resistance measurement
- Continuity testing
- Diode testing
Index of Contents
1. Operating instructions
2. Safety instructions
3. Scope of delivery
4. Meter description
5. General Specifications
6. Ambient Conditions
7. Electrical Specifications
8. Measuring with BENNING MM 2
9. Maintenance
10. How to use the protective rubber holster
11. Technical data of the measuring accessories
12. Environmental note
1. Operating Instructions
This operating manual is intended for
- electrical professionals
- qualified electrotechnical persons
The BENNING MM 2 is designed for measuring in dry conditions and must not
be used on electrical circuits with a rated voltage greater than 1000 V DC and
750 V AC ( for details refer to "Ambient Conditions" section).
The following symbols appear in this manual and on the BENNING MM 2:

This symbol indicates dangerous voltage.

This symbol indicates warnings and cautions to be observed when
using the BENNING MM 2 (refer to manual!)
This symbol on the BENNING MM 2 indicates that the BENNING MM 2
has double insulation (Protection Class II)
This symbol on the BENNING MM 2 indicates the unit contains
built-in fuses.
This symbol appears in the display when the battery is low.
This symbol indicates the "Continuity testing" mode is selected.
The buzzer sounds for acoustic test results.
This symbol indicates the "Diode testing" mode is selected.
(DC) Direct voltage or current.
(AC) Alternating voltage or current.

Ground ( voltage against earth)
05/ 2019
Operating manual
BENNING MM 2
BENNING MM 2

9