Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11. INSTALLING THE GREASE TRAY
Parts Required:
Grease Tray (#18)
1
x
1
x
Grease Tray Handle (#19)
Installation:
•
Remove the pre-mounted screws from the side shelf handle. On the
edge of the grease tray with two holes, align the handle with the holes,
then hand-tighten the screw (from the inside) into the handle. Note 11A.
•
Slide the grease tray into the tray opening on the front panel of the
unit. The grease tray is completely inserted once the front of the tray
is flush with the front panel of the unit. Note 11B.
12. SECURING THE CHIMNEY
Parts Required:
Chimney Gasket (#6)
1
x
Chimney Stack (#7)
1
x
1
x
Chimney Cap Assembly (#8)
Installation:
•
Locate the chimney opening on the side of the main barrel. Remove
the pre-installed screws.
•
From the outside of the main barrel, secure the chimney gasket and
chimney stack to the side panel by re-installing the two screws. The
screw will fasten to the pre-mounted nut on the inside of the barrel.
•
Next, secure the chimney cap onto the top of the chimney stack with
the screw and nut.
NOTE: Adjust the chimney cap to affect the airflow inside the main
grill. If cooking at low temperature, keep the cap more open. Ensure
the chimney cap allows for air to escape.
13. INSTALLING THE BOTTLE OPENER
Parts Required:
1
x
Bottle Opener (#10)
Installation:
•
Remove the two pre-mounted screws for the bottle opener on the side
of the hopper, above the hopper handle. Install the bottle opener in the
same location using the two screws previously removed.
11A
19
11B
12
6
13
10
18
8
7
10
Publicité
Chapitres
Table des Matières
