Placing The Grease Bucket; Installing The Spice Box, Bottle Opener; Connecting To A Power Source - Pit Boss Sportsman PB0820S Guide De Montage

11. PLACING THE GREASE BUCKET

Parts Required:
1 x Grease Bucket (#28)
Installation:
• Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.

12. INSTALLING THE SPICE BOX, BOTTLE OPENER

Parts Required:
1 x Spice Box (#9)
1 x Bottle Opener (#8)
Installation:
• Remove the top two screws on the side of the Hopper, below the hopper
handle. Align and place the Spice Box onto the bottom two screws, push
down into place, then re-install the top two screws to secure the Spice
Box onto the Hopper.
• Remove the two pre-mounted screws for the Bottle Opener on the side
of the Hopper, above the hopper handle. Install the Bottle Opener in the
same location using the two screws previously removed. The unit is now
completely assembled.

13. CONNECTING TO A POWER SOURCE

NOTE: Before plugging your Pit Boss
the temperature dial is in the OFF position.
STANDARD OUTLET
•
This appliance requires 110-120 volt, 60hz, 275w, 5 amp service. It must
be a 3-prong grounded plug. Ensure grounded end is not broken off
before use. The control uses a 5 amp, 110-120 volt, fast-blow fuse to
protect the board from the igniter.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity, which
can be too much power for a GFCI outlet to handle. Each time it trips, it
increases in sensitivity. If the GFCI keeps tripping, replace the outlet or
change to a non-GFCI outlet.
ON THE ROAD
•
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. A Pit Boss
inverter plugged into your automobile outlet. To use the automatic
igniter, it is recommended to use a minimum of a 1000 watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
Refer to Owner's Manual for Operating Instructions.
11
into any electrical outlet, ensure
®
unit can operate using a 12 volt, 100 watt
®
11
28
12
8
9
13
FAST-BLOW FUSE,
5 AMP