Oregon PCS 3840 Manuel D'utilisation page 15

14 14
MM EN
2. Fuel filter
1. Using a wire hook, take out the filter from the
filler port.
2. Disassemble the filter and wash with gaso-
line, or replace with a new one if needed.
NOTE
• After removing the filter, use a pinch to hold
the end of the suction pipe.
• When assembling the filter, take care not to
allow filter fibers or dust inside the suction
pipe.
3. Spark plug
Clean the electrodes with a wire brush and reset
the gap to 0.65 mm as necessary.
4. Sprocket
Check for cracks and for excessive wear inter-
fering with the chain drive. If the wear is consid-
erable, replace it with new one. Never fit a new
chain on a worn sprocket, or a worn chain on a
new sprocket.
All manuals and user guides at all-guides.com
(1) Fuel filter
5. Front and Rear dampers
Replace if adhered part is peeled or crack is
observed on the rubber part. Replace if the
inside of the rear damper metal has been beaten
by the stopper bolt and the clearance of the
metal increased.
7. Maintenance