Footrests - Sunrise Medical Zippie RS Manuel D'utilisation

7.0 Footrests

Various footboards are available. These can be flipped up to
make it easier to transfer to/from the chair. They are described
individually.
Footrest and swing away latch
When fitting the footrests these are fitted in the swung-away
position (Fig. 7.1). Then simply turn them inwards until the
interlock engages (1). To remove the footrests, use the lever (2)
and swing the footrest outwards and lift off. Check that the
footrest is correctly engaged.
WARNING!
The footrests are not designed to be used to lift or carry the
wheelchairs with an occupant.
Hanger play adjustment
In case of play the hanger (Fig. 7.2) can be adjusted in the
field. The hanger pin (1) is tapered and the play can be reduced
when the pin is unscrewed slightly.
Take the hanger off the chair in using the release mechanism.
Use an screw driver and turn the pin (1) in the front carefully to
the left. Then test the hanger on the chair. If the hanger
mechanism is not working/catching anymore, please undo the
task slightly.
If the play is still too large and the performance not accepted,
please repeat the task.
Lower leg lengths
By undoing the clamp screw (Fig.7.3), you can adjust the lower
leg length. Loosen the clamp screw, adjust the tube with the
foot-board to the desired position.
Tighten clamp screws again (see the page on torque). Ensure
that the plastic push joint is located under the clamp screw in
the correct position.
WARNING!
Do not stand on the foot-board!
When transferring, do not stand on the foot-board, there is a
risk of tipping over and injury.
Central mount footplate (Fig. 7.4):
The central mount footplate has to be insert into the receivers
underneath the seat plate. The lower leg length, (1), footboard
angle, (3) and knee angle, (2), are all adjustable. Please loosen
the butterfly screw and do the setting. Afterwards tighten the
screw again.
WARNING!
Tighten all fittings after adjustment.
Zippie RS Rev.1.0
Fig. 7.1
1
Fig. 7.2
Fig. 7.3
Fig. 7.4
2
3
2
1
1
33