Hilti VC 20-U-Y Mode D'emploi page 46

2. Lift the vacuum cleaner top section away
from the waste material container and
place it on a level surface.
7.9.1.2 After emptying the waste material
container, proceed as follows:
CAUTION
en
When fitting the top section of the vacuum
cleaner, take care to avoid pinching your
fingers or damaging the supply cord.
7.10 Using the appliance as a charging station
Overview of the charging station status indicator
.
7.10.1 Charging status display
While the green charge status LED on the charging station lights constantly, if one of the two
charge status LEDs blinks this indicates that charging is in progress.
7.10.2 Indication of too high / too low temperature
The green charge status LED will blink If the battery is too hot or too cold. At the same time, the
LEDs on the battery indicate the charge status of the Li‑ion battery.
7.10.3 Indication of a defective battery
Remove the battery from the charging station If the green status LED on the charging station
lights constantly but all charge status LEDs do not light. If all charge status LEDs on the battery
fail to light even after being activated then the battery is defective. Have the battery tested at a
Hilti center.
42
All manuals and user guides at all-guides.com
Fit the vacuum cleaner top section onto the
waste material container and close the two
catches.
7.9.2 Emptying the waste material
NOTE
The material collected must be disposed of in
accordance with the applicable regulations.
1. Hold the container by the grip areas
2. Clean the edge of the waste material con-
LED lights constantly
LED blinks
LED doesn't light
container when no dust bag is fitted
(collecting liquids)
provided and tip it over to empty out its
contents.
tainer with a damp cloth.
The appliance is connected to
the electric supply and is ready
for use.
The battery is too cold or too hot
and is not being charged. The
charger switches automatically
to charging mode as soon as
the battery reaches the required
temperature.
Charger malfunction. Unplug
the appliance and then plug it
in again. If the LED still doesn't
light, the appliance should be re-
turned to a Hilti Service Center
for repair.