Cleaning & Maintenance - CONTINENTAL EDISON CEMP838DIG2 Guide D'utilisation

V. CLEANING & MAINTENANCE
1. Unplug the power cord from the wall socket and let
the unit cool completely before cleaning.
2. Immediately after removing the bread dish, fill the dish until
halfway with warm water and a small amount of dishwashing
liquid. Allow the dish to soak for 5 to 20 minutes or until knead
bar can be removed from the shaft. It is possible that you
were slightly twist the bar to release it. It is possible that the
kneading bar having to soak in water before being removed.
If the kneading bar is difficult to remove after soaking, attach
the crossbar below the flat while rotating knead bar to loosen.
Wash the inside of the dish and the kneading bar with a soft
cloth, rinse and dry. Use a medium power detergent. Never
use chemical cleaners, oven cleaners, scouring pads or
abrasive detergents on the bread pan or knead bar as this
may damage the finish or finish. Place the kneading bar on
the axle.
3. Do not immerse the bread pan in water or wash
never automatic dishwasher as this may damage the bearings
that drive the kneading bar. Wipe the inside of the oven
compartment and the outer surfaces of the bread maker with a
damp cloth if necessary. Never immerse the device in water or
never fill the baking compartment with water! The cover cannot
be removed for cleaning.
NOTE: The coating on the inside of the bread pan may
change color over time; This is normal and does not
affect the bread making.
EN-23