For Use In Hazardous Areas - FLUX GS Notice D'instructions

2.5

For use in hazardous areas

The Ex marking is II 2G h IIB T4 Gb.
> Attention!
 The drive motor (driven electrically or with compressed-air)
> Caution - risk of injury!
 Follow internal instructions (explosion protection document).
 Wear protective clothing (face, ear and breathing protection,
> Attention!
 Avoid dry running of the pump in any case.
> Attention!
 Never leave the pump unattended.
> Attention!
The gear is for operation at an ambient temperature of - 20°C up
to + 40°C.
> Attention!
Regularly check coupling and driver on wear.
> Attention!
 Observe the EC type examination certificate and the certificate
 The pump must not be used as a stationary unit in hazardous
> Explosion hazard!
 For use in hazardous locations only use explosion-proof electric
 If the motors/gears are operated together with the pump,
 Connect the electric motor with an explosion-proof plug or via an
 For equipotential bonding, an electrically conductive connection
must not exceed the power output of 550 W.
protective gloves, etc.).
of conformity, respectively.
locations.
motors which are approved for category 2 (ZONE 1) or compressed
air motors.
comprehensive, clear equipotential bonding is essential (earthing).
explosion-proof cable terminal box.
must be produced between the motor/gear and the pump according
to DIN EN 60079-0 and DIN EN 60079-14.
Original operation instructions planetary gear 17/36