Tools You Will Need - Quickie SOPUR P-220 Manuel D'utilisation Et Garantie

20
IX. SET-UP, ADJUSTMENTS AND USE
NOTES
1. Work surface for set-up:
Use a flat surface, such as a table, to assemble, adjust and check your chair. This makes
the steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-strength fasteners and
may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert to help prevent loosening.
• Only use screws, bolts and nuts provided by Sunrise Medical.
1. Use of improper fasteners may cause the chair to fall.
2. Over- or under-tightened fasteners may fail or cause damage to chair parts.
3. If bolts or screws become loose, tighten them as soon as you can. Loose bolts or
screws can cause damage to other chair parts causing them to fail.
3. Washers and spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers when you reassemble
parts.
4. Torque settings:
• A torque setting is the optimal tightening for a particular fastener. Use a torque
wrench that measures inch-pounds to secure screws, nuts and bolts on this chair.
NOTE– Unless otherwise noted, use a torque setting of 120 inch-pounds (13.5 Nm) for all fasteners.

TOOLS YOU WILL NEED

1. Basic Tool Kit:
To set-up, adjust and maintain your chair you will need the following tools:
• 7/16" box and open-end wrench
• 1/2" box and open-end wrench
• 3/4" box and open-end wrench
• 5/32" Allen wrench
• 3/16" Allen wrench
• 1/8" Allen wrench
• Phillips screwdriver #2
• Custom axle wrench (or a 1/2" open-end wrench)
You can obtain a multi-purpose tool kit from Sunrise Medical or buy the tools you need
from a hardware store.
2. Torque Wrench
If you plan to adjust and maintain this chair yourself, Quickie/Sopur recommends that you
use a torque wrench.
NOTE– The wrench must measure inch-pounds and Nm. You can buy a torque wrench and proper sock-
ets from a hardware store.
CHECK-OUT
Be sure this chair performs to your chosen operational settings. If it does not, turn the
chair off immediately and contact your supplier.
NOTE– Repeat this procedure until the chair performs to your specifications.
When properly set-up, this chair will operate smoothly. Check to see that all com-
ponents work properly. If you detect a problem, be sure to correct it before use.
930479 Rev. C
All manuals and user guides at all-guides.com
E n g l i s h
I X . S e t - u p , A d j u s t m e n t s a n d U s e