Symbols And Definitions; Before You Begin - Tuthill H Serie Manuel D'installation Et D'utilisation

|
H-Series Fuel Transfer Pumps Have the Following Features
• Adjustable Electrical Junction Box
Rotates 180 degrees to provide ease of electrical wiring installation
in tight quarters no matter the inlet bung location
• Reliable, Heavy-Duty Power Switch Lever
Features a cast metal stop that withstands heavy use in the
most rugged environments
• Locking Bar Defense
Elongated bar simplifies the pad locking process to prevent theft
• Focused Component Weight Reduction
Preserves expected heavy-duty performance while
improving installation ease
About This Manual
From initial concept and design through final production, your Fill-Rite fuel transfer pump is built to provide years of trouble-free use. To ensure the safety
of yourself and those around you, it is critical that this manual is read in its entirety prior to attempting to install or operate your new purchase. We strongly
urge that any installer and operator become familiar with the terms, diagrams, and technical data in this manual and pay close attention to warning
symbols and definitions. At Tuthill, your satisfaction with our products is paramount. If you have questions or need assistance with your product, please
contact Customer Service at 1-800-634-2695 (M-F, 8am-6pm EST/EDT).

Symbols and Definitions

Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in moderate or minor injury.
Indicates information considered important but not directly hazard related.

Before You Begin

Fueling Requirements
The Fill-Rite FR1200, FR2400, FR4200, FR4400, FR600 as well as SD1200 and SD600 models are designed and approved for use with the following
flammable and combustible fluids: gasoline and gasoline blends up to 15% or E15, diesel, biodiesel blends up to 20% or B20, kerosene, and mineral spirits.
Please take all necessary precautions when handling flammable liquids.
Power Source Requirements
Depending on the Fill-Rite model, supply line power will either be 12V DC, 24V DC, or 115V AC. The pump motor nameplate located next to the switch lever will
provide detailed electrical information. Please refer to the appropriate electrical instructions found starting on Page 7 (DC power) or Page 10 (AC power).
Items that may be needed for installation:
Steel pipe wrench 14-24", open end wrench or socket (7/16", 11mm), T-25 Torx driver, utility knife, angle grinder or hacksaw (optional), wire cutters, wire
stripper/crimper, and thread sealant (optional).
tape for all models as listed on Page 16.
Note: Tuthill provides Teflon
®
fillrite.com | tuthill.com
H-SERIES FUEL TRANSFER PUMPS
INSTALLATION AND OPERATION MANUAL
• Premium Paint Shield
An exemplary corrosion resistant barrier for long field life
• Thermally Protected Motor
Prevents overheating to ensure maximum motor life
• Telescoping Inlet Metal Suction Pipe*
Adjustable from 20 to 34 inches in length, allowing for universal
installation on a multitude of tank sizes and shapes
*Not included with SD models
• Intake Strainer Safeguard
Protects the pump by blocking particles created by contamination
• Certifications – UL, cUL
3