Safety Testing Approvals; Motor Tag Information - Tuthill H Serie Manuel D'installation Et D'utilisation

Safety Testing Approvals

The Fill-Rite line of pumps have been safety tested for regulatory compliance. This
product family is approved by UL/cUL. For the "E" series products they are approved to
ATEX, IECEx, INMETRO, EAC, and CE.
2809
The following standards were used to show compliance in the European Union:
EN IEC 60079-0:2018, Ed 7 "Explosive atmospheres – Part 0: Equipment –
General requirements"
EN 60079-1:2014, Ed 7 "Explosive atmospheres – Part 1: Equipment protection
by flameproof enclosures "d""
EN ISO 80079-36:2016, Ed 1 "Explosive atmospheres – Part 36: Non-electrical
equipment for explosive atmospheres – Basic method and requirements"
EN ISO 80079-37:2016, Ed 1 "Explosive atmospheres – Part 37: Non-electrical
equipment for explosive atmospheres – Non electrical type of protection
constructional safety "c", control of ignition source "b", liquid immersion "k""
Directive 2014/34/EU – Equipment and protective systems intended for use in
potentially explosive atmospheres.
Directive 2011/65/EU – Restrictions of the use of certain hazardous substances in
electrical and electronic equipment.
The following standards were used to show compliance for IECEx certification:
IEC 60079-0:2017, Ed 7
IEC 60079-1:2014, Ed 7

Motor Tag Information

The Motor Tag on your Fill-Rite pump
contains important technical and
performance information. Be certain
this label remains affixed to the pump
at all times.
Installation
Pump must be installed in compliance with EN 60079-14 or IEC 60079-14, as
applicable.
Material of Construction
Materials of construction of the external surface of the unit: painted steel, painted
cast iron, painted aluminum, zinc plated steel.
Materials of construction of the wetted parts: cast iron, zinc plated steel, 300 series
stainless steel, bronze, carbon, ceramic, polyester, fiber, fluorocarbon, buna.
Repair and Maintenance
Contact the place of purchase for warranty repair and maintenance.
Specific Conditions of Use
1.
Consult the manufacturer if dimensional information on the flameproof joints is
necessary.
2.
ISO Class 4.6, M5 hex-head screws (Yield Stress 240 MPa) shall be used to replace
the DC Motor terminal cover fasteners.
3.
ISO Class 8.8, M6 hex-head screws (Yield Stress 640 MPa) shall be used to replace
the DC Motor motor tie-rod fasteners.
4.
An electrically conductive hose and nozzle must be used with flammable liquids.
To minimize static electricity buildup, always keep the nozzle in contact with the
container being filled during the fueling process.
Motor Tag Information
The motor tag on your Fill-Rite pump contains important technical and
performance information. Be certain this label remains affixed to the
pump at all times.
II 2 G
Ex db h IIA T5 or T6 Gb
FM19ATEX0019X
IECEx FMG19.0013X
Ex db IIA T5 or T6 Gb
Tuthill Corporation
8825 Aviation Drive
Fort Wayne, Indiana 46809 USA
P (800) 634-2695
(+01) 260-747-7524
F (800) 866-4681
tuthill.com | fillrite.com | sotera.com
FIL-MN-712v.2