Horizon Fitness BT5.0 Manuel D'utilisation page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

LOCATION OF THE EXERCISE BIKE
Place the exercise bike on a level surface. There should be 3 feet of clearance behind the
exercise bike, 3 feet on each side and one foot in front for the power cord. Do not place
the exercise bike in any area that will block any vent or air openings. The exercise bike
should not be located in a garage, covered patio, near water or outdoors.
MOVING THE EXERCISE BIKE
Your exercise bike has a pair of transport wheels built into the front stabilizer tube.
Remove the power supply before attempting to move the bike.
WARNING
Our exercise bikes are heavy, use care and additional help if necessary
when moving. Failure to follow these instructions could result in injury.
UPRIGHT BIKES: firmly grasp
LEVELING THE EXERCISE BIKE
the handlebars, carefully tip
Your exercise bike should be level for optimum use. Place
toward you, and roll on the
your exercise bike where you intend to use it. Adjust the
transport wheels.
two rear levelers so that the bike is level on the floor.
Then adjust the third leveler located under the base
frame tube just so it is snug with the floor. Once you have
leveled your exercise bike, lock the levelers in place by
tightening the nuts against the frame. Actual levelers may
differ from image below and may not include the lock.
8
HZ17_OM_BT5.0_Rev_1_A.indd 8-9
SEAT POSITIONING
1 ft 31 cm
To determine proper seat position, sit on the seat and position the ball of your foot on the center of the pedal. Your knee should bend
slightly at the furthest pedal position. You should be able to pedal without locking your knees or shifting your weight from side to side.
NOTE: It is recommended that you do not sit on the seat while adjusting its position.
3 ft
3 ft
92 cm
92 cm
UPRIGHT BIKES - SEAT ADJUSTMENT
Upright Bikes feature a locking seat adjustment pin to easily and safely adjust the seat height. To adjust, get off the bike seat and
loosen the adjustment knob by turning it two half turns counter-clockwise. Pull out the knob to unlock the post, and adjust the post up
or down to the desired setting. Release the knob to lock in place. Turn the knob clockwise until tightened. Please check to be sure seat
post is locked in place before each use.
3 ft 92 cm
ADJUST HEIGHT
9
2/15/17 3:06 PM

Publicité

Table des Matières
loading

Table des Matières