Sartorius Stedim Biotech arium 61316 Mode D'emploi page 7

Control Panel|Display
Operate the arium ® system using
the control panel that features four
function keys and two control keys
for the cursor.
Standby Key
Press the Standby key to switch the
unit into "Standby" mode. The pro-
duction of reverse osmosis water
will be interrupted and a 4 minute
automatic backflush cycle will rinse
the RO modules. By flushing the
modules, any residues that build up
on the untreated water side during
operation will passed into the drain.
The life time of the cartridges will
be expanded.
Operate Key
With the Operate key you can
interrupt the "standby" mode
and activate the unit. Afterwards
the system will start an internal
initialisation and check the feed
pressure of the system and the
tank. The arium ® 61316 will switch
in the "operate" mode to produce
RO water, if the tank pressure is
< 2.5 bar.
When the system is in the "operate"
mode, the display will show:
XX % Rejection Rate
XX μS/cm comp.
_ _ _ _ _ _ _ _ _ _ Tank Level
Time
Menu Key
This key is used to view the System
Menu and all its options.
MENU
Cursor Keys
Use these two arrow keys to move
within the menu and highlight
individual menu items. With the
key, move the cursor up
a line, with the
the cursor down a line.
Enter Key
Use the Enter key to confirm a
menu item you have selected with
the cursor.
Power Connection|Main Switch
Note
The arium
to single phase power sources
ranging from 100-240 VAC with
50-60 Hz.
1. Use the supplied power cord and
plug it into the outlet on the lower
left side of the system.
2. The system power is located on
lower left side. Press ("I") on to
Date
activate the system and ("O") to
deactivate the system.
Note
All installations have to be finished
before activating the system.
Maintenance
Setup
Info
key, move
®
61316 can be connected
arium SYSTEM RO
S/N XXXXXXXX
System Check....
V.X.XX
Standby Enter
Operate
Menu
Control Panel|Display
AC power connector port, left-hand
side of housing
7