Clamp Tools; Leveling Tailstock To Headstock; Speed Change - HOLZMANN MASCHINEN ED 300FD Mode D'emploi

Tour à métaux

Masquer les pouces Voir aussi pour ED 300FD:

Table des Matières

Les langues disponibles

13.4.3 Clamp tools

The tool must be clamped tighten.

During the rotating operation of the tool has a tendency to bend away from the workpiece.

The cut angle is correct if the cutting edge is in line with the central axis of the workpiece. The

correct height of the tool can be achieved by comparing the tool tip with the live center in the

tail-stock tip.

If necessary, the tool must be adjusted by using steel parallels.

Tighten properly between spindle and tailstock up a 200mm long solid piece of pipe.

Now clamp a indicating caliper into the tool holder.

Run with manual feed (handwheel) the top slides along the workpiece. When measuring

differences of tailstock is adjusted using the adjustment screw on headstock with tailstock (11)

until no more measuring differences exist.

The

ED can 400FD within 2 speed ranges

operated.

To change the speed range of

belt must be allocated.

 Loosen and remove the two screws on the handle head

headstock cover (17) and remove the gear cover.

 marked allen screw - left behind drive wheel- loosen and

loosen Belt C.

 Place put the V-belt C on the respective pulleys.

There are 2 positions (siehe figure at right)

Pos. A (outer pulleys) for lower speed range.

Pos. B (inner pulleys) for high speed range.

After changing the belt must be tensioned and then remount the cover.

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at

operation,

the drive

OPERATION

ED300FD

Table des Matières