AL-KO CMI 1000 Manuel D'utilisation page 20

0DLQWHQDQFH ZRUNV
Sr€‚‰vtÇurÆph…vsvr…Ã…‚yyr…Ãvp‡ˆ…rÃ@Ã
1. Unscrew the screw (1) from the bearing.
2. Flap up the bearing half (3).
3. Lift the scarifier roller from the lower bearing
half and pull it out from the drive side (2).
To re-assemble proceed in reverse order.
Srƒyhpvtà ‡urà †ph…vsvr…à …‚yyr…à iyhqr†ÃÃ
ƒvp‡ˆ…rÃAÃ
I‚‡r)
7rs‚…r qv†h††r€iyvt ‡ur iyhqr y‚‚x h‡
v‡† €‚ˆ‡vt ƒ‚†v‡v‚
+HOS LQ IDXOWV
Qˆyy ‡ur ƒyˆt ‚ˆ‡ hq hv‡ ˆ‡vy ‡ur iyhqr …‚yyr… uh† p‚€r ‡‚ h †‡hq†‡vyy irs‚…r h’ €hv‡r
!
hpr hq pyrhvt ‚…x
Ahˆy‡Ã
Motor does not run
Roller does not rotate
Motor output drops
Poor scarifying perform-
ance
Noisy running, application
vibrates
Fault, which cannot be rectified with the help of this table, may only be attended to by an authorized
company (workshop).
(QYLURQPHQWDO SURWHFWLRQV GLVSRVDO
Do not dispose of worn-out units through the household garbage!
The appliance, its packaging and accessories are all produced from recyclable materi-
als and must be disposed of accordingly.
GB 4
8hˆ†rÃ
No voltage
Roller blocked
Toothed belt defective.
Working depth too high
Dirty housing
Lawn too long for scarifying
Working depth too high
Worn blades
Blade damaged
1. Unscrew the hexagon bolt (1).
2. Carefully remove the ball bearing (2) from
the shaft (8).
3. Remove pressure ring (3), disk (4) and short
distance sleeve (5) from the shaft.
4. Successively remove blade (6) and long
distance sleeves.
To re-assemble proceed in reverse order.
The disassembly of the aerator roller and re-
placement of the steel spring beaks must be
made analogously to the scarifier roller.
Sr€rq’Ã
Check connection line and connec-
tion protection switch
Check roller
Workshop.
Select lower working depth
Clean housing
Lawn too long for scarifying
Select lower working depth
Replace worn blade
Workshop