Swash Special Mode Operations - brondell Swash S1200-EW Manuel De L'utilisateur

OPERATING THE SWASH (cont.)

SWASH SPECIAL MODE OPERATIONS

NOTE:
• Special Mode Operations can be changed following the instructions below using the
Auxiliary Controls on the side of the bidet (see pages 20 and 24).
Selecting/Canceling Eco Mode
When the Eco Mode function is selected, the Swash will go into Eco Mode when the Seat Sensor
is not activated and no buttons on the Remote have been active for approximately 10 minutes.
The seat heater will automatically set itself to the Low temperature setting to reduce power
consumption. Once Eco Mode is activated, the Eco Mode light on the seat will turn green and the
other lights will turn off.
Eco Mode is cancelled at the factory by default.
1. Press and hold down the Power and Rear Cleansing auxiliary buttons simultaneously
for approximately 5 seconds until one or more of the seat display lights start flashing. Release
the buttons.
NOTE: If the nightlight is turned on, it will also flash.
2. Press the Rear Cleansing button to Set or Cancel Eco Mode.
a. If the Eco Mode indicator light is flashing, this indicates Eco Mode has been set.
b. If the Eco Mode indicator light is not flashing, this indicates Eco Mode has been cancelled.
3. The new setting will automatically be saved within 10 seconds if no other buttons are pressed,
or if you press the Stop button on the remote control.
4. The Eco Mode indicator light will illuminate when the Seat Sensor is not activated and no
buttons on the Remote control have been active for approximately 10 minutes.
Selecting/Canceling Silent Mode
By default, the Swash will beep to confirm commands from the remote control. Follow the steps
below to deactivate the beeping sounds.
1. Press and hold down the Power and Rear Cleansing auxiliary buttons simultaneously
for approximately 5 seconds until one or more of the seat display lights start flashing. Release
the buttons.
NOTE: If the nightlight is turned on, it will also flash.
2. Press the Power button to Set or Cancel silent mode.
a. If the Power indicator light is flashing, this indicates Silent Mode has been set. There will not
be any beeping sounds when buttons on the Remote Control are pressed.
b. If Power indicator light is turned off, this indicates the Silent Mode has been canceled.
Beeping sounds when buttons on the Remote Control are pressed will resume.
3. The new setting will automatically be saved within 10 seconds if no other buttons are pressed,
or if you press the Stop button on the remote control.
26