brondell Swash S1200-EW Manuel De L'utilisateur page 23

USING THE SWASH 1200/1400
NOTES:
• The wash functions will not work unless the sensor in the seat detects someone sitting
down (skin conductivity sensor). To override the Seat Sensor, please refer to the section
on page 27.
• The remote control will not operate the Swash if the batteries are weak, dead, or not
installed properly (remote requires 4 x CR2032 batteries to function).
Warm Water Aerated Wash
1. Sit on the seat to ensure skin-to-seat contact. The seat will give an audible response letting you
know the seat sensor has been engaged. At the same time an automatic self-cleaning cycle
will occur - a small amount of water will flush over the nozzles and into the toilet bowl.
2. Press the Front or Rear button on the remote to begin water flow. The nozzles will self-clean
and purge a small amount of water which will last for several seconds prior to starting the wash
function – please note that this may take up to 20 seconds.
The front or rear wand will extend and wash for 2 minutes, then turn off automatically.
3. To keep the wash continuing longer than 2 minutes, press the Front or Rear button again
during the wash cycle. Each time you press the button during the wash cycle, the 2 minute
cycle starts again.
4. If you would like to stop the wash before the 2 minute cycle ends, press the Stop button to
discontinue flow.
5. While washing, users can adjust the water temperature, water pressure, spray width, and
nozzle position according to their preferences.
5. After the wash cycle, the nozzles will perform a self clean cycle purging water for approximately
5 seconds.
NOTE:
• You cannot increase the water pressure level to higher than level 2 under the following
conditions: Main water supply temperature is under 50° F or if the rated power source is
under 110V.
Nozzle Positioning
While the wash function is operating, use the Nozzle Position up and down arrows on the remote
control to move the position of the nozzles and spray. Each nozzle has seven positions.
Water Pressure Adjustment
While the wash function is operating, press the Water Pressure "+" and "-" buttons on the remote
control to increase or decrease the water pressure of the spray. There are three water pressure
levels: Low – Med – High.
21