brondell Swash S1200-EW Manuel De L'utilisateur page 22

OPERATING THE SWASH (cont.)
BIDET SEAT CONTROLS GUIDE
Basic functions such as Rear Cleansing and Nozzle Cleaning can be used without the remote by
utilizing the auxiliary buttons shown below.
1
2
3
4
1
SEAT DISPLAY
1. Remote IR Receiver (3)
Receives signal from remote control.
2. Power Indicator
This indicator is illuminated when the bidet is powered on.
This indicator is turned off when Eco Mode is activated.
3. Eco Mode Indicator
This indicator is illuminated when Eco Mode is enabled and activated, ten minutes after the
Swash was last used or programmed.
4. Seat Temperature Indicator
This indicator is illuminated when the seat temperature is set to Low, Medium, or High.
The indicator is turned off when the seat temperature is off. This indicator is also turned off
when Eco Mode is activated.
AUXILIARY CONTROL PANEL
5. Power Button
Turns the seat On/Off. Press and hold the button for 2 seconds to turn off.
If the Power button is pressed while any wash function is operating, the wash function will stop.
6. Rear Cleansing Button
Initiates the rear wash function utilizing the settings last used.
7. Nozzle Cleaning Button
When pressed, one nozzle will fully extend, allowing for easy cleaning. Press again for the
second nozzle to extend and once more to retract both nozzles.
20
7
6
5
1