brondell Swash S1200-EW Manuel De L'utilisateur page 15

Siège de toilette bidet luxe
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SWASH INSTALLATION (cont.)
6. Connect the Bidet Hose to the Seat
a. Connect the bidet hose to the water inlet. Hand-tighten
to secure. Take care not to twist the bidet hose, exces-
sively bend it, or strip the plastic screw threads when
screwing the hose onto the bidet seat.
7. Attach the Swash to the Mounting Plate
a. Set the Swash flat on the toilet bowl in front of the
mounting plate, and slide seat onto plate until it is
secure and "clicks" into place.
b. If the seat appears too short or too long for the toilet,
adjust the mounting plate accordingly. To adjust the
mounting plate, loosen barrel nuts underneath the toilet
and slide seat forward or backwards as needed. Once
the seat is lined up properly, tighten barrel nuts to hold
in place.
8. Connect the open end of the Bidet Hose to the T-Valve.
9. Turn On Water Supply
a. Open the main water supply valve slowly and check for
leaks.
b. Wait 5 minutes, check again and if there are no leaks
continue.
10. Connect Power
a. Plug the power cord into the electrical outlet.
b. If desired, use the included Cable Clips to connect the
power cord and bidet hose side-by-side for a tidier
appearance.
NOTES:
• Make sure to only use a grounded GFCI (ground
fault circuit interrupter) electrical outlet. In the case
of a short circuit, a grounded GFCI outlet may help
prevent electric shock or injury.
• If it is necessary to use an extension cord, only use
those rated for a minimum of 15 amps with a three-
wire extension cord with a three-blade grounding
plug.
Step 6a
Step 7b
Step 8
Step 10b
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Swash s1200-rwSwash s1400-ewSwash s1400-rwSwash s1400-ebSwash s1400-rbSwash 1200 luxury ... Afficher tout

Table des Matières