brondell Swash S1200-EW Manuel De L'utilisateur page 19

QUICK REFERENCE GUIDE – S1200 REMOTE CONTROL (cont.)
SEE DIAGRAM ON PAGE 16
1. Remote IR Signal Transmitter
Transmits the signal from remote control to the seat when a button is pressed.
2. Rear Wash Button
This button activates the aerated Rear Wash function.
3. Front (Feminine) Wash Button
This button activates the aerated Front, or "Feminine", Wash function.
4. Stop Button
Stops all functions currently operating.
5. Water Pressure Buttons
These buttons increase or decrease the water pressure, to one of three settings, during either
of the aerated wash cycles.
6. Nozzle Position Buttons
These buttons move the wash nozzle, to one of seven positions, during either of the aerated
wash cycles.
7. Seat Temp. & Indicator
Indicates the Seat Temperature setting. Press the button to cycle through each setting.
Off, Low - 89° F (blue), Medium - 93° F (pink), High - 97° F (red)
8. Spray Width & Indicator
Indicates the wash Spray Width setting. Press the button to cycle through each setting.
Concentrated (blue), Medium (pink), and Wide (red)
9. Water Temp. & Indicator
Indicates the Water Temperature setting. Press the button to cycle through each setting.
Off - incoming water temp., Low - 90° F (blue), Medium - 95° F (pink), High - 100° F (red)
10. User Memory 1
This button contains the programming for all of the customizations set in User 1's wash cycles.
See page 23 for more details.
11. Auto Mode
This button automatically runs a pre-programmed wash (front or rear) cycle. See page 22 for
more details.
12. User Memory 2
This button contains the programming for all of the customizations set in User 2's wash cycles.
See page 23 for more details.
17