brondell Swash S1200-EW Manuel De L'utilisateur page 26

OPERATING THE SWASH (cont.)
USING THE SWASH 1200/1400 (cont.)
User Memory Setting (cont.)
Using the User 1 or User 2 Memory Function
1. Sit on the seat. The seat will give an audible response letting you know that the seat sensor
has been engaged (unless "Silent Mode" has been set to On). At the same time, a small
amount of water will flush over the nozzle, performing an automatic self-cleaning cycle.
2. Press the User 1 or User 2 button followed by the Front or Rear button, depending on which
wash cycle was programmed. You will hear an audible tone if you select a wash cycle that
has not been programmed.
3. The nozzles will self-clean and purge a small amount of water which will last for several
seconds prior to starting the programmed wash function. The Water Temperature Level,
Spray Width Level, Nozzle Position, Water Pressure Level, and Oscillation function will be set
to the programmed settings. The wash cycle will run for 2 minutes and shut off automatically.
4. To keep the wash continuing longer than 2 minutes, press the Front or Rear button again
during the wash cycle. Each time you press the button during the wash cycle, the 2 minute
wash cycle will start over again.
5. If you would like to stop the wash before the 2 minute cycle ends, press the Stop button.
IMPORTANT NOTES REGARDING USER MEMORY SETTINGS:
• After pushing the User 1 or User 2 button you have 5 minutes before the memory function
is cancelled.
• If the seat sensor is de-activated at any time after pushing the User 1 or User 2 button, the
memory setting function will be cancelled.
• When you use the User 1 or User 2 memory settings, the LED indicator lights on the remote
may not reflect your saved preferences, but your programmed Front and Rear wash
settings will be accurate and correct.
• After programing both nozzles for a User, if you decide to change the programing of one
nozzle, you must reprogram both nozzles.
Auxiliary Controls
1. Power button – Turns the product On/Off. Press and hold the button for at least 2 seconds to
turn off the Swash.
NOTE:
• If the Power button is pressed while front or rear wash is operating, the wash function
will stop.
2. Rear Cleansing – Selects the rear wash function.
3. Nozzle Cleaning – To better clean the nozzles, press this button, the nozzle will extend fully for
easy cleaning. Refer to Maintenance section for additional nozzle cleaning information.
24