brondell Swash S1200-EW Manuel De L'utilisateur page 21

QUICK REFERENCE GUIDE – S1400 REMOTE CONTROL (cont.)
SEE DIAGRAM ON PAGE 18
1. Remote IR Signal Transmitter
Transmits the signal from remote control to the seat when a button is pressed.
2. Rear Wash Button
This button activates the aerated Rear Wash function.
3. Front (Feminine) Wash Button
This button activates the aerated Front, or "Feminine", Wash function.
4. Stop Button
Stops all functions currently operating.
5. Nozzle Oscillation (Move) Button
This button activates the Nozzle Oscillation function. When activated, the front or rear nozzle moves
back and forth during the wash cycle to clean a wider area. Push the button again to stop the
oscillation.
6. Dry Button
Turns on the Warm Air Dryer for a period of two minutes.
7. Water Pressure/Dry Temperature Buttons
These buttons increase or decrease the water pressure, to one of three settings, during either of the
aerated wash cycles. During the Dry cycle, these buttons increase or decrease the temperature of the
Warm Air Dryer.
8. Nozzle Position Buttons
These buttons move the wash nozzle, to one of seven positions, during either of the wash cycles.
9. Water Temp. & Indicator
Indicates the Water Temperature setting. Press the button to cycle through each setting.
Off - incoming water temp., Low - 90° F (blue), Medium - 95° F (pink), High - 100° F (red)
10. Spray Width & Indicator
Indicates the wash Spray Width setting. Press the button to cycle through each setting.
Concentrated (blue), Medium (pink), and Wide (red)
11. Seat Temp. & Indicator
Indicates the Seat Temperature setting. Press the button to cycle through each setting.
Off, Low - 89° F (blue), Medium - 93° F (pink), High - 97° F (red)
12. Nozzle Sterilizer
Utilizing silver as a natural antibacterial agent, this sterilizing wash is 100% chemical and
maintenance-free, keeping the nozzles clean, hygienic, and corrosion-free.
13. Deodorizer
Eliminates odors by removing air from the toilet bowl, passing it through the replaceable active
carbon filter, and expelling the clean air through the vent in the back of the Swash.
14. User Memory 1
This button contains the programming for all of the customizations set in User 1's wash cycles.
See page 23 for more details.
15. Auto Mode
This button automatically runs a pre-programmed wash (front or rear) and dry cycle. See page 22 for
more details.
16. User Memory 2
This button contains the programming for all of the customizations set in User 2's wash cycles.
See page 23 for more details.
19